IDG News Service - HP scientists have made a small breakthrough in the development of a next-generation memory technology called memristors, which some see as a potential replacement for today's widely used flash and DRAM technologies.
In a paper to be published Monday in the journal "Nanotechnology," scientists report that they have mapped out the basic chemistry and structure of what happens inside a memristor during its electrical operation.
Previously, although working memristors had been built in the labs, scientists didn't know exactly what was happening inside the tiny structures. So while HP was already confident it could commercialize the technology, this discovery will allow it to greatly improve its performance, said Stan Williams, a senior fellow at HP.
"We were on a path where we would have had something that works reasonably well, but this improves our confidence and should allow us to improve the devices such that they are significantly better," he said.
Memristors were first described in 1971 by a professor at the University of California, Berkeley. Prior to that, scientists knew of only three basic circuit elements -- the resistor, the capacitor and the inductor. Professor Leon Chua posited that there was a fourth.
Decades later, scientists at HP proved that memristors existed, and further proved that they could be made to switch back and forth between two or more levels of electrical resistance, which would allow them to represent the ones and zeros in digital computing.
Scientists knew that switching process was taking place but found it hard to study because memristors are so tiny. HP's latest breakthrough was to use highly focused X-rays to pinpoint a channel, just 100 nanometers wide, where the resistance switching takes place. A nanometer is one billionth of a meter.
They then mapped out the chemistry and structure of that channel, and thus gained a better idea of how memristors operate. The paper was jointly published by HP and UC Santa Barbara.
The type of memory that can be built with memristors, called ReRAM, is nonvolatile, which means devices can retain their data after the power supply is turned off. That's in contrast to DRAM, where the stored data is lost when the power is cut.
Williams estimated that HP's memristor technology could be commercially available by the middle of 2013, though "that's not an official promise from HP as a company," he said.
HP has built sample devices in its labs that should enable storage densities of 12G bytes per square centimeter, Williams said That's using a 15-nanometer production process and a multi-level design, where four layers of memory cell are stacked on top of one another.
- Cloud-to-Cloud Backup Case Study: AMAG Pharmaceuticals As an IT pioneer in the pharmaceuticals industry, AMAG realized that SaaS backup and recovery would give them the confidence to fully embrace...
- 9 Essentials for a Complete Cloud-to-Cloud Backup Solution In 9 Essentials for a Complete Cloud-to-Cloud Backup Solution, we'll walk you through potential sources of data loss in the cloud and provide...
- Report: Back Up Critical Cloud Data before It's Too Late Read the February 2014 Forrester Research Inc. Report, Back Up Your Critical Cloud Data Before It's Too Late: Cloud-To-Cloud Backup Emerges As A...
- Mobile Content, Collaboration & IDC's 3rd IT Platform: The Next Frontier for the Mobile Enterprise IDC focuses this article on talks about the new IT platform. This 3rd IT Platform will be the new wave for about the...
- The Key to Happiness: Throw out Your Data Warehouse In this webinar, Kerry Reitnauer, Director, Solution Architect at FairPoint Communications will discuss the challenges the data warehouse brought, how they migrated to...
- The Foundation You Need to Build a Better Storage Infrastructure Watch this webcast to hear how you can maximize the economics of your data center by modifying your storage footprint and power usage... All Data Storage White Papers | Webcasts