We pit two new SATA 6Gbit/sec. hard drives against older peers to see how much faster they really are.
Those of us in the business of keeping an eye on new technologies wonder why the buzz about SATA 6Gbit/sec. (a.k.a. Serial ATA Revision 3) hasn't been louder than it is.
SATA 6Gbit/sec. is the next-generation SATA specification and will double the speed of the current SATA standard (which is 3Gbit/sec.). The technology was first demonstrated by Seagate and AMD in March 2009, and is finally coming to market. So why haven't we heard more about it?
Even some hard drive manufacturers are being coy about the new specification. For example, a Western Digital representative, when asked about the company's 1TB SATA 6Gbit/sec. Caviar Black, said that Western Digital had not made a major announcement because SATA Revision 3 just represents an interface change.
Just an interface change? Yes, technically that's correct. SATA Revision 3's speed rating -- like all of the other SATA and Parallel ATA (PATA) ratings -- is actually a measurement of the speed at which data travels from the hard disk's onboard cache to the interface on your PC. It really has nothing to do with the speed of the drive itself.
So is this new SATA technology irrelevant? Not at all. One only has to imagine its use with drives having higher rotational speeds than the current 7,200 rpm (they get to the data more quickly); drives with larger onboard cache (that will hold more data in readiness for the interface to absorb); and even SSDs where none of the offsets of mechanical hard disks exist. It could significantly improve performance in all of those scenarios.
Even with the current crop of drives -- especially with those that have increased cache values of 64MB and up -- SATA 6Gbit/sec. should add some increase in burst speed and sequential reads or writes to contiguous disk sectors. These procedures maximize the continuous streaming of data that a faster interface speed can take advantage of.
To see how much of an advantage this new technology will add, I tested two new SATA 6Gbit/sec. hard drives: The 1TB Western Digital WD Caviar Black ($120) and Seagate's 2TB Barracuda XT desktop hard drive ($260).
Like the new USB 3.0 specification, SATA 6Gbit/sec. is a whole new technology. If you want to use a SATA 6Gbit/sec. hard drive, you'll need a motherboard that provides a SATA 6Gbit/sec. interface (which, if you're building your own system, will cost somewhere between $140 and $240, depending on the type of features you want). If you don't want to replace your motherboard, you can add a SATA 6Gbit/sec. plug-in card, such as the Asus U3S6, to an existing motherboard. Be aware, however, that these cards usually require an x4 PCIe slot and you might be hard-pressed to find an available one in your current PC inventory.
To take full advantage of the technology, you'll also want a system with at least an Intel Core i5 processor (to make use of Intel's SATA 6Gbit/sec.-supporting X55 chip set), at least 4GB of memory and a decent graphics card.
You're managing countless tasks to run the business; you want expertise to fill in the gaps to meet...
Does protocol matter when you are building out your storage? Is it a hardware choice? Maybe a software...
One company's misfortune is another's lucky day. Salesforce isn't going to enjoy the upcoming...
Samsung is now producing the industry’s first 512GB NVMe PCIe SSD in a single ball grid array (BGA)...
Breaches that weren’t have gotten a lot of attention — and that’s not such a bad thing.
A detailed look at the most meaningful changes coming to Android via this year's yet-to-be-named N...
DJI’s new Phantom 4 drone makes high-flying tech easier with a variety of new features that will...